Wall Formwork System

AlpiFlex 50

H20&Waler Formwork System

Alpine H20 & Waler formwork AlpiFlex50 is designed to be tailored to (into?) various types of tasks - so provides the ideal scope for adapting the shapes and sizes of the elements to suit your structure. The element size-grid and tie-hole pattern provide the adaptability needed to accommodate architectural demands. The AlpiFlex elements and exact connections make for a perfect joint pattern. You can choose whichever form-face material that best meets your requirements - e.g. for smooth fair-faced concrete, wood-textured surfaces, intensive re-use etc. A range of practical accessories makes work on the site a lot easier and prevents the need for costly in-situ improvisations.

Versatility

For all shapes and loads;

Flexible panel widths according to the length of the steel walers.
Flexibility regarding the height of the panels, which is determined by the H20 girder length (standard lengths 2.45 m to 5.90 m; special lengths up to 12.00 m).
Tie positions can be adjusted according to project requirement.
Any architectural requirement.
Any formwork pressure.
Any type of form-facing.

Fast, efficient working

Thanks to optimized formwork solutions. Cost-efficient project implementation thanks to:


Flexible panel widths according to the length of the steel walers.
Individualized solutions.
High numbers of re-use cycles.
Short forming-times.
Elongated holes in the steel walers and panel couplings allow 100 % tension and compression-proof panel connections resulting in tight panel joints.
Large, optimized shifting unit.

AlpiFlex-Circular

Circular Wall Formwork System

Circular wall formwork is used in specific projects featuring circular walls; sewage treatment plants, spiral ramps in car-parks, circular tanks etc. Circular formwork H20 is a practical circular formwork system that delivers smooth, curved walls.

Fast, efficient and easy working

There are only two connecting devices (Panel Clamp and Panel Lock)
The system can easily be combined with AlpiMax, and AlpiLight panel formwork systems.
The radius is easily set by turning spindles.

Single Side Supporting Frame

The safe way to form single-sided walls

Single Side Supporting frames” enable the concreting forces to be safely transferred by way of diagonal anchors in cases where it is not possible to use tie-rods in AlpiFlex50 or AlpiMax panel formwork through the concrete.

Adjustable down to the last cm thanks to innovative combinability.
The unique “Supporting construction frame” permits continuous adjustability, thanks to its practical attachable frames.
Supporting construction frames save time and cost from high-speed repositioning, the right repositioning solution in every case by crane.
Enhanced safety thanks to its unrivalled range of accessories, even greater safety thanks to standardized solutions; concrete forces are safely transferred.

AlpiMaX Formwork Panel

Cost-effective, thanks to high number of re-use cycles For crane-handling gang-forming of large areas

Reduced close-out costs thanks to superior product quality Highly economical, thanks to
• its high quality 13ply sheets.
• its rugged powder-coated steel frames.
• the fact that the film faced plywood sheets is easy to clean, recondition and replacement.
Swifter working due to the low form-tie count Wide spacing (up to 1.20 m) between form-ties means;
• shorter forming-times.
• lower labor costs.
Easy handling and planning thanks to logical system-grid
The 15 cm grid, with only 6 different widths of panel, results in
• optimum adaptability to every layout.
• compact gang-forms for short crane times
• easy planning and logistics
• a neat joint pattern
High safety for your site
The accident risk is reduced, and legally compliant working conditions are ensured, by
• combining the formwork with the working Platform bracket.